[prev in list] [next in list] [prev in thread] [next in thread]
List: quanta
Subject: Re: [Quanta] Debugging in Quanta 3.4
From: Kimberly Lazarski <kim () biyn ! com>
Date: 2005-04-28 3:55:10
Message-ID: 1114660510.5273.6.camel () kim2p3lin ! biyn ! local
[Download RAW message or body]
Hi Mark,
On Wed, 2005-04-27 at 19:06, Mark Howells wrote:
> OK,
>
> On 4/27/05, Linus McCabe <Linus@mccabe.nu> wrote:
> >
> > Yes, it's backported so please try the 3.4 branch from CVS!
Sorry I should have specified that. Thanks for the addition Linus!
> >
> > /Linus
>
> So I grabbed the latest 3.4 branch from CVS and built it. It
> identifies itself as
>
> "Quanta post-3.4.0 (Using KDE 3.4.0)"
>
> However, nothing much seems to have changed. Whenever I toggle a
> breakpoint I have to specify source directory mappings, and as soon as
> I launch the page (using) StartSession I have to specify the same,
> once for each breakpoint - even though I have set directory mapping
> Debugger Options for the project... :(
Mark, if you set the basedirs prior to the upgrade, go back to the
project properties and re-set them. If you're running into the same
issue I did, you will find that setting the basedirs again then saving
the project will fix the problem.
It did not seem to "remember" the settings I applied prior to the
upgrade. Also, as Linus pointed out earlier this month, if all of the
files are local then you should set the basedirs to "/"
--Kim
>
> Any ideas anyone
>
> Mark
>
> >
> _______________________________________________
> Quanta mailing list
> Quanta@mail.kde.org
> https://mail.kde.org/mailman/listinfo/quanta
--
No virus found in this email - I run Linux. ;)
_______________________________________________
Quanta mailing list
Quanta@mail.kde.org
https://mail.kde.org/mailman/listinfo/quanta
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic