[prev in list] [next in list] [prev in thread] [next in thread]
List: comedi
Subject: Re: how to create a timer controlled analog-in command
From: Caleb Tennis <caleb () aei-tech ! com>
Date: 2006-06-16 10:30:09
Message-ID: E285422E-ECDA-40FE-8F25-18DEBAD6C490 () aei-tech ! com
[Download RAW message or body]
>
> Once I tried running comedi_calibrate with channels 1-5 directly
> shorted out
> to ground, separated from my circuit. Then I connected my circuit
> to channels
> 1-5. I measured the voltage at the board with a voltmeter, where
> the circuit
> output is connected to the DAQ. Then I ran inpn.c. Here's my
> results:
Make sure you have your signal ground connect to AIGND on the NI
terminal strip. Also make sure you're running inpn with AREF_GROUND
and not AREF_DIFF or something else. It's an option you can pass
to ./inpn, something like ./inpn -a 0 I believe.
Caleb
_______________________________________________
comedi mailing list
comedi@comedi.org
https://cvs.comedi.org/cgi-bin/mailman/listinfo/comedi
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic