[prev in list] [next in list] [prev in thread] [next in thread]
List: linux-omap
Subject: RE: OMAP3xxx hsmmc : MMC3 doesn't work, always times out?
From: "Gadiyar, Anand" <gadiyar () ti ! com>
Date: 2009-06-11 17:51:47
Message-ID: 5A47E75E594F054BAF48C5E4FC4B92AB03059BB9AD () dbde02 ! ent ! ti ! com
[Download RAW message or body]
<snip>
>
> You are quite possibly correct, but the level translator I'm using is
> "invisible" - it doesn't require the transceiver control signals
> offered only on MMC2. So as far as I know, there is no hardware reason
> the OMAP MMC3 controller couldn't talk correctly at the electrical
> level with the card. This is evidenced by the CMD signal being
> correctly level translated (and this is via the same type of level
> translator as the data signals are according to the TXS02612
> datasheet), and toggling correctly(-looking) at the card socket (i.e.
> between 0 and 3.3V and it's edges synced to the clock signal). The
> DAT0-DAT3 signals never do anything though.
The MMC3 DAT0-DAT3 lines are muxed with MMC2 DAT4-DAT7. Any chance the
padconfs are being overwritten even though you programmed them
correctly in the bootloader?
- Anand
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic