[prev in list] [next in list] [prev in thread] [next in thread]
List: linux-bridge
Subject: [Bridge] Possible bug in the Bridge-utils/HostAP driver
From: "Manjunathan PY" <pymanju () miel ! mot ! com>
Date: 2002-06-24 4:32:24
[Download RAW message or body]
Hi,
I have setup a bridge between wirless LAN and Wired LAN as shown below
(Bridge Br0 on Linux box)
____________________
| |
station....air if....wlan0---HostAP---eth0---wiredLAN---Proxy---internet
|____________________|
I am not able to browse the internet from the station. I used ethereal on
the HostAP linux box (which is also acting as bridge )
to monitor the http request, I noticed that http request reaches the
internet Proxy server. But the station is not able to receive any packets
from the internet proxy.
Note: I used bride-utils by Lennert Buytenhenk to setup the bridge in the
linux box , I am using Prism2 HostAP driver.
Route table is as follows
Destination Gateway Genmask Flags Metric Ref Use
Iface
217.1.128.0 * 255.255.255.0 U 0 0 0 br0
loopback * 255.0.0.0 U 0 0 0 lo
default gateway.irc.com 0.0.0.0 UG 0 0 0 br0
Can any one please explain why I am NOT able to browse the internet? The
browser used to display "Connected to www.google.com ..." and thats it. No
further response at all.
After a lot of struggle, I figured out that if I set the MTU size (Maximum
Transmission Unit) to anything less than 1400 bytes in the Station, I was
able to browse the internet.
What could be the problem!, why is that I have to change the MTU size to
make it work.
Thanks in advance,
Manjunathan Padua Y
_______________________________________________
Bridge mailing list
Bridge@math.leidenuniv.nl
http://www.math.leidenuniv.nl/mailman/listinfo/bridge
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic