[prev in list] [next in list] [prev in thread] [next in thread]
List: kde-devel
Subject: Re: Debugging a kio_slave
From: Craig Howard <craig () choward ! ca>
Date: 2006-08-10 7:02:46
Message-ID: 200608100002.46995.craig () choward ! ca
[Download RAW message or body]
On Tuesday 08 August 2006 22:49, Craig Howard wrote:
> I'm trying to debug a kio slave that I'm writing, but I'm running into
> difficulties. I've read DEBUG.howto in kdebase/kioslave and I've set
> KDE_SLAVE_DEBUG and re-run kdeinit.
>
> However, when I open a url that is handled by my ioslave, nothing is output
> on the terminal. I figured out the pid by looking at the output of ps (so
> my ioslave is running) and I attached gdb to kdeinit at that pid. I can
> set breakpoints to functions within my slave, but when I continue, gdb just
> hangs! My konqueror instance that I used to load the url just spins
> indefinately. Not attaching using gdb and just sending a SIGCONT produces
> the same behaviour.
>
> Have I missed a step? Thanks.
For the record, I was doing it right, I must have had a mismatched library
version after an apt-get upgrade. Sorry about that.
--
Craig Howard
craig@choward.ca
Software Engineer - Amazon.com
BMath CompSci - University of Waterloo
>> Visit http://mail.kde.org/mailman/listinfo/kde-devel#unsub to unsubscribe <<
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic