[prev in list] [next in list] [prev in thread] [next in thread]
List: elecraft
Subject: [Elecraft] Problen with initial tests for KPA100
From: "Dave" <dcrock () attbi ! com>
Date: 2002-11-30 1:31:33
[Download RAW message or body]
I have completed the KPA100 build up to page 23 of the manual. I =
installed the upgraded firmware versions for the K2, MCU (ver. 2.03d), =
K2IOC (ver. 1.07) and KSB2 (ver.1.07) that came with the KPA100. All =
initial tests were in spec. (except pin 27 on U1, should be 12-15V, =
found to be 0.62V) but when I powered up the K2 it did not function. The =
display did not light, no buttons functioned, no audio. Correct =
orientation of the IC's were verified. When I reinstalled the old =
firmware everything was fine again. Does anybody have any idea what =
would cause this to happen.
Thanks,
Dave
--- StripMime Report -- processed MIME parts ---
multipart/alternative
text/plain (text body -- kept)
text/html
The reason this message is shown is because the post was in HTML
or had an attachment. Attachments are not allowed.
Please post in Plain-Text only.---
_______________________________________________
Elecraft mailing list: Elecraft@mailman.qth.net
You must be a list member to post to the list.
Postings must be plain text (no HTML or attachments).
See: http://mailman.qth.net/mailman/listinfo/elecraft
Elecraft Web Page: http://www.elecraft.com
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic