[prev in list] [next in list] [prev in thread] [next in thread]
List: cisco-nsp
Subject: [nsp] Primary Rate Isdn Configuration
From: Vicky Fyrigou <vfyr () forthnet ! gr>
Date: 1998-02-09 17:47:38
[Download RAW message or body]
Hello all,
I would appreciate very much your help on the following:
We just got our PRI connection from our PTT and we will use
it on a Cisco 3640.
The question is the following:
I found out that I can use both channel-groups and pri-group in
a way as follows:
controller e1 3/0
channel-group 0 timeslots 1-2
channel-group 1 timeslots 3-4
channel-group 2 timeslots 5-13
pri-group timeslots 14-31
In that case, I suppose that I'll be able to use the B13-B30 channels
for dial-up (I've already made some successful tests), and the interfaces
3/0:0, 3/0:1, 3/0:2 as separate interfaces for backup purposes.
The point is how can I setup the above interfaces with dialer options?
I have not been able to give dialer commands for these interfaces.
Thanks in advance,
Vicky Fyrigou
TECHNICAL DEPARTMENT
FORTHnet S.A.
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic