[prev in list] [next in list] [prev in thread] [next in thread]
List: kde-nonlinux
Subject: Re: [Kde-nonlinux] how to use Konqueror behind a firewall
From: "Ivan Carey" <icarey () bigpond ! com>
Date: 2002-05-27 9:04:38
[Download RAW message or body]
Lauri,
I tried this and when I rebooted it stoped half way through the process. I
then commented out this line defaultrouter="192.168.1.1" and posted my
question.
All I have now done is uncomment the line in the rc.conf, rebooted and
everything is now working.
Thanks for your help,
Ivan
----- Original Message -----
From: "Lauri Watts" <lauri@kde.org>
To: <kde-nonlinux@kde.org>
Sent: Sunday, May 26, 2002 8:47 PM
Subject: Re: [Kde-nonlinux] how to use Konqueror behind a firewall
On Sunday 26 May 2002 11.06, Ivan Carey wrote:
> How do I use Konqueror behind a firewall?
> I do not have a proxy server installed.
> My network consists of a FreeBSD box a Windows 2000 box and a FreeBSD
> firewall connected to the internet via dialup. I can get the Windows 2000
> box to use the firewall by telling the network setup to use the firewall
as
> a gateway. The only way to use Konqueror that I can see is via a proxy
> server.
The same way. Tell the FreeBSD box to use the FreeBSD firewall as the
gateway
In rc.conf, add the address of the gateway as follows:
defaultrouter="192.168.15.254"
or if you're more comfortable that way, use /stand/sysinstall (-->
Post-install configuration --> networking --> interfaces, and add the
address
of the firewall as the IPv4 gateway)
Regards,
--
Lauri Watts
_______________________________________________
kde-nonlinux mailing list
kde-nonlinux@mail.kde.org
http://mail.kde.org/mailman/listinfo/kde-nonlinux
_______________________________________________
kde-nonlinux mailing list
kde-nonlinux@mail.kde.org
http://mail.kde.org/mailman/listinfo/kde-nonlinux
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic