[prev in list] [next in list] [prev in thread] [next in thread]
List: zebra
Subject: [zebra 351] Re: zebra & gated
From: Kunihiro Ishiguro <kunihiro () zebra ! org>
Date: 1999-03-22 14:37:30
[Download RAW message or body]
Hi, this is Kunihiro.
>The neighbor's router ID is 207.204.248.34, but we need to peer with
>207.204.248.81 (its address on the interface between the gated machine and
>my zebra test machine).
>
>It seems like Zebra does not like the difference in router ID and
>neighbor address. Is this the case?
Currently Zebra does not use router ID as neighbor's IP address
identifier. So one must configure neighbor's IP address as TCP/IP
connection's source address or TCP/IP connection destination address.
>1999/03/22 00:35:37 OK I got BGP connection from host 207.204.248.34
It seems that there was a connection from 207.204.248.34. Is this IP
address assigned to the gated machine? If so below configuration may
work.
router bgp 65501
bgp router-id 207.204.248.82
neighbor 207.204.248.34 remote-as 7369
neighbor 207.204.248.34 route-map set-nexthop out
I've just read RFC1771 and draft-ietf-idr-bgp4-08.txt. It seems that
router identifier is for connection collision detection. I'm not sure
other routing software or verndor software's convention about this.
Any comments or suggestions are welcome.
--
Kunihiro Ishiguro
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic