[prev in list] [next in list] [prev in thread] [next in thread]
List: xfree-newbie
Subject: Re: Re: [Newbie]ADI Microscan 3V / S3 Trio3D / XF86 3.3.6 / hi-res
From: "Phil" <yeehaa () edsamail ! com ! ph>
Date: 2001-06-26 0:51:11
[Download RAW message or body]
Hi Alex!
newbie@XFree86.Org wrote:
> > The first time I installed it, when the installer attempted to detect
> > my video settings, the monitor went blank and there was no response from my
> > computer.
>
> It was the same here immediately after I installed Mandrake 7.2 with XF86 4.0.1.
> Although XF3.3.6 worked just fine (after I tweaked the XF86Config) (SVGA server,
Can you attach a copy of your XF86Config (the oneyou used for XF 3.3.6)? Tnx.
> haven't tested the S3 one), the 4.0.1 performed exactly as you describe. After I
> installed 4.0.3, it became a _bit_ better, although the problems still existed.
> The final solution I found was to abandon the
> vga=788
> kernel option (the one Mandrake had chosen upon install due to unknown -- to
> me;-) reasons) and to revert to
> vga=normal
> After that I've configured SVGATextMode instead of the kernel support for the
> SVGA CLI. That did the trick, although I don't know what the heck the
> problem was in the first place. Kernels tested: 2.2.x, 2.4.0.
>
> I'm interested in your experience: whether the trick described above helps or
> not etc.
>
Can this "vga" setting be found in XF86Config? How about "SVGATextMode"?
> > I tried tweaking XF86Config but failed. The problem doesn't seem to be the
> > monitor. It seems to be S3Trio3D video card. The X server always detects it as
> > S3 Virge, runs XAA (X Accelerated Architecture), then my computer monitor goes
> > blank again and hangs.
>
> It's not the monitor. In my experience, XF86 4.0.1. just used to hang the
> videocard. At some point I tried the "vga" driver, which resulted in monitor
> reporting that it was instructed to use vert. refresh of 0 (!!!) Hz. Usual crap
> "waiting 15 seconds" etc. etc. followed;-)
>
In my case, the XF86_VGA16 driver worked fine with me (640x480x16 colors), but the \
XF86_SVGA and XF86_S3 didn't.
Thanks a lot!!
Phil
__________________________________
www.edsamail.com
_______________________________________________
Newbie mailing list
Newbie@XFree86.Org
*** To unsubscribe , or change message options, see:
http://XFree86.Org/mailman/listinfo/newbie
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic