[prev in list] [next in list] [prev in thread] [next in thread]
List: usrp-users
Subject: Re: [USRP-users] B210 vs. E310: different behaviour when acquiring signal samples
From: Martin Braun via USRP-users <usrp-users () lists ! ettus ! com>
Date: 2016-02-29 18:48:59
Message-ID: 56D4929B.6030206 () ettus ! com
[Download RAW message or body]
We do, through the property tree.
These are the properties we expose:
/mboards/0/dboards/A/rx_frontends/A/gain/agc/enable
/mboards/0/dboards/A/rx_frontends/A/gain/agc/mode/value
/mboards/0/dboards/A/rx_frontends/A/gain/agc/mode/options
Cheers,
M
On 02/26/2016 04:38 PM, Marcus D. Leech via USRP-users wrote:
> On 02/25/2016 12:17 PM, Maurizio Crozzoli via USRP-users wrote:
>> Marcus D. Leech via USRP-users <usrp-users@...> writes:
>>
>>
>>> Maurizio:
>>> While the B210 and E310 use the same RF chip--the AD9361, the E310
>>> has a layer of switchable filters in front of the AD9361, and an
>>> external amplifier to compensate for filter loss.
>>> What power level are you sending from your signal generator?
>> RS EPRE is in the range -100 | -45 dBm/15kHz (the corresponding full
>> cell BW
>> Power would be -81.4 | -26.4 dBm for a 1.4 MHz ch. BW).
>>
>> Any comments of Gain/AGC?
> AGC is not enabled on the AD9361--I can't remember whether we have an
> API to turn it on or not, but by default it's OFF.
>
>
>
>
> _______________________________________________
> USRP-users mailing list
> USRP-users@lists.ettus.com
> http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
_______________________________________________
USRP-users mailing list
USRP-users@lists.ettus.com
http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic