[prev in list] [next in list] [prev in thread] [next in thread]
List: strongswan-users
Subject: Re: [strongSwan] Any special settings for RDP over a Strongswan IPsec VPN?
From: Alex Red <alexthered88 () hotmail ! com>
Date: 2013-09-30 21:51:34
Message-ID: 5249F266.9040707 () hotmail ! com
[Download RAW message or body]
Do you think my difficulty is because my Strongswan runs on a Linux
server with only one LAN interface, so there is some double-natting
going on?
Here is a picture:
http://i.imgur.com/sLYA0Dh.png
(remote PC on the right wants to RDP into the Windows PC on the lower left)
I had to enter the following command on the Strongswan server to get
traffic-flowing from remote PC to the Internet/Intranet. Just wondering
if maybe this could be causing this issue or this command needs adjustment?
===> iptables -A POSTROUTING -t NAT -j SNAT --to-source 192.168.0.50 <===
(192.168.0.50 is the Linux server running Strongswan)
Thank you so much.
Regards,
Lawrence
On 9/30/2013 4:41 PM, Jakob Curdes wrote:
> Am 30.09.2013 23:07, schrieb Lawrence Chiu:
>> Are there any special settings that are required to get RDP to work?
>> Thanks!
>>
> No, definitely not. We are using rdp sessions via IPSec VPNs over a
> daily basis without problems, even on slow or a bit lossy connections.
> I would look for firewalling or other connectivity problems.
>
> Regards JC
>
> _______________________________________________
> Users mailing list
> Users@lists.strongswan.org
> https://lists.strongswan.org/mailman/listinfo/users
>
>
_______________________________________________
Users mailing list
Users@lists.strongswan.org
https://lists.strongswan.org/mailman/listinfo/users
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic