[prev in list] [next in list] [prev in thread] [next in thread]
List: snap
Subject: RE: [SNAP] RTS signal
From: "Christian Blixt" <christian.blixt () imsystech ! com>
Date: 2008-01-09 9:24:05
Message-ID: NCBBIMLDODFMMFCFADJBAEJKHBAA.christian.blixt () imsystech ! com
[Download RAW message or body]
Hi,
But it does work! I just tried it, both on a rev C module and a rev F
module, both with 1.0.9 firmware.
Attached you'll find the test program I used. It toggles the RTS line for
each character sent over serial1, and checks the RTS line status
programmatically. I also measured the pin (71) and it worked exactly as
expected, both on rev C and rev F.
Regards,
Christian Blixt
Tel: +46 (0)8 594 110 82
christian.blixt@imsystech.com
Imsys Technologies AB
Tel: +46 (0)8 594 110 70
Fax: +46 (0)8 594 110 89
www.imsystech.com
-----Original Message-----
From: snap-bounces@listserver.songnetworks.se
[mailto:snap-bounces@listserver.songnetworks.se]On Behalf Of Eduardo
Freire
Sent: den 8 januari 2008 13:02
To: snap@imsystech.com
Subject: [SNAP] RTS signal
The SerialPort setRts(bool) method on revision F, revision 1.0.9, is not
working. I had to manipulate the ports directly by BitPort (ETH_EESK and
Port3Bit4) in order to use this control signal...
Regards,
Eduardo Freire
CSI Engenharia e Sistemas
(11) 4072-9999
Visite nosso site http://www.csi.ind.br
_______________________________________________
Snap mailing list
snap@imsystech.com
http://www.imsystech.com/support/maillist.htm
["CommEchoJavaX.java" (java/*)]
_______________________________________________
Snap mailing list
snap@imsystech.com
http://www.imsystech.com/support/maillist.htm
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic