[prev in list] [next in list] [prev in thread] [next in thread]
List: sendmail
Subject: Re: sendmail as client - port selection
From: lars.bjonnes () aptilo ! com (=?iso-8859-1?q?Lars_Gullik_Bj=F8nnes?=)
Date: 2004-10-29 9:10:50
Message-ID: 1041029101650.~INN-DTBa00150.comp-news () dl ! ac ! uk
[Download RAW message or body]
"Andrzej Adam Filip" <anfi@priv.onet.pl> ( http://anfi.homeunix.net/ ) writes:
| Lars Gullik Bjønnes wrote:
>> I have a setup with a SMART_HOST and AuthInfo setup, the problem is
>> that the SMART_HOST does not listen on the regular smtp port. But uses
>> a special port (24 in this case). Currently I use the firwall do to
>> destination nat (DNAT) to this port, but it would be a lot nicer if it
>> were possible to do this directly in the sendmail config.
>> Is this possible?
>> Or is the DNAT way the only possible?
>
| http://www.sendmail.org/faq/section3.html#3.39
| Q3.39 -- How do I send using an alternate port?
| Date: May 5, 2002; Updated: January 10, 2004
Ok, thanks. I did actually google quite a bit for a solution, but I
didn't see the above.
--
Lgb
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic