[prev in list] [next in list] [prev in thread] [next in thread]
List: rrd-users
Subject: [rrd-users] RRD update command question
From: mark.smith () comdev ! cc (Mark Smith)
Date: 2001-04-20 18:59:32
Message-ID: 3AE08714.9030504 () comdev ! cc
[Download RAW message or body]
I'm trying to send an update command via RRDp to an rrd with roughly
40,000 variables. I'd like to update as many of these as possible on a
single command line. The problem is that not all data sources have the
same time stamp. If I did an update line like this:
update <filename> -t data1:data2:data3 time1:data1 time2:data2 \
time3:data3
Would that apply three different datapoints to data1 or would it apply
one data point to each of data1, data2 and data3 (as I would hope)?
To rephrase the question a bit, does update expect the data in this form:
update <filename> -t data1:data2:data3 time:data1:data2:data3
If that's the case, is there a way to specify different time stamps to
each datapoint, or can I only update data with the same timestamp on a
given command line?
I appricate y'all's help. :)
-Mark
--
Unsubscribe mailto:rrd-users-request at list.ee.ethz.ch?subject=unsubscribe
Help mailto:rrd-users-request at list.ee.ethz.ch?subject=help
Archive http://www.ee.ethz.ch/~slist/rrd-users
WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic