[prev in list] [next in list] [prev in thread] [next in thread]
List: pykde
Subject: Re: [PyQt] PyQt5 configure.py --enable=MODULE
From: Phil Thompson <phil () riverbankcomputing ! com>
Date: 2017-11-27 8:37:08
Message-ID: 9C86419F-1899-4BE9-959D-F62FB1DF438C () riverbankcomputing ! com
[Download RAW message or body]
On 27 Nov 2017, at 2:29 am, Davide Pesavento <pesa@gentoo.org> wrote:
>
> Hi,
>
> It seems that when passing the --enable option to configure.py,
> check_modules() is not called. For some modules, this means that the
> corresponding config-tests/cfgtest_* is not built and run, which
> results in mis-detection of some Qt features and potential build
> failures later on.
>
> Is this a known bug?
It's not a bug. If you are specifically telling configure to build a module (rather \
than letting it decide) then it assumes you will do it for everything.
Phil
_______________________________________________
PyQt mailing list PyQt@riverbankcomputing.com
https://www.riverbankcomputing.com/mailman/listinfo/pyqt
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic