[prev in list] [next in list] [prev in thread] [next in thread] 

List:       pfsense-support
Subject:    Re: [pfSense Support] Nokia IP110 report - problem booting
From:       Chris Buechler <cbuechler () gmail ! com>
Date:       2005-03-16 3:13:53
Message-ID: d64aa176050315191376b051d9 () mail ! gmail ! com
[Download RAW message or body]

On Mon, 14 Mar 2005 22:52:56 -0800, Michael Mee <mm2001@pobox.com> wrote:
> Thanks to help earlier from Bill and Chris, I took a stab at getting
> pfSense running on the Nokia IP110 (see
> http://chrisbuechler.com/m0n0wall/nokia/ip110.html and
> http://www.socalfreenet.org/nokiaip110 for more info on the box).
> 
> The short version is... It boots but crashes - see full bootlog way below.
> 

Same here.  I loaded mine up the "traditional" way, putting the HD
into a laptop and running a typical install then putting the drive
into the IP110 and firing it up.

Got pretty much exactly what you got.  Console output at the bottom of
this message.

-Chris


Copyright (c) 1992-2005 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993,
1994
        The Regents of the University of California. All rights
reserved.
FreeBSD 5.4-PRERELEASE #7: Sun Mar  6 00:36:55 UTC 2005
    sullrich@builder.livebsd.com:/usr/obj/usr/src/sys/FREESBIE.5
Timecounter "i8254" frequency 1193182 Hz quality 0
CPU: Geode(TM) Integrated Processor by National Semi (266.68-MHz
586-class CPU)
  Origin = "Geode by NSC"  Id = 0x540  Stepping = 0
  Features=0x808131<FPU,TSC,MSR,CX8,CMOV,MMX>
real memory  = 67108864 (64 MB)                               
avail memory = 56184832 (53 MB)                               
module_register_init: MOD_LOAD (vesa, 0xc0893bbc, 0) error 19
npx0: <math processor> on motherboard                                     
npx0: INT 16 interface
pcib0: <Host to PCI bridge> pcibus 0 on motherboard
pir0: <PCI Interrupt Routing Table: 3 Entries> on motherboard
pci0: <PCI bus> on pcib0


Fatal trap 12: page fault while in kernel mode
cpuid = 0; apic id = 00
fault virtual address   = 0xeb11f
fault code              = supervisor read, page not present
instruction pointer     = 0x8:0xc00eb621
stack pointer           = 0x10:0xc0c20a4c
frame pointer           = 0x10:0xc0c20a4c
code segment            = base 0x0, limit 0xfffff, type 0x1b
                        = DPL 0, pres 1, def32 1, gran 1
processor eflags        = interrupt enabled, resume, IOPL = 0
current process         = 0 (swapper)
trap number             = 12
panic: page fault
cpuid = 0
Uptime: 1s
Automatic reboot in 15 seconds - press a key on the console to abort
Rebooting...

[prev in list] [next in list] [prev in thread] [next in thread]