[prev in list] [next in list] [prev in thread] [next in thread] 

List:       openbsd-ppc
Subject:    Re: Successfull Install, Unsuccessful boot
From:       "Bruce O'Neel" <openbsd () pckswarms ! ch>
Date:       2007-12-07 20:02:35
Message-ID: 1197057755-306af3d370736e48a0daf7fdb1993930 () pckswarms ! ch
[Download RAW message or body]

Hi,

Thanks for the offer of help with the B&W G3.

Amusing enough I've not had the problem of MBR installs not booting.

I've installed 4.2 on a B&W G3, a Lombard (both with network problems), a Pismo
(no network problems, dmesg below), and the already reported G4 powerbook (a 667
I believe with gigabit ethernet).  I think, though I'm not 100% sure, that I \
installed 4.2 on a toilet seat ibook as well.  In all cases cases the MBR booting \
worked just fine.

Thanks!

cheers

bruce

Copyright (c) 1982, 1986, 1989, 1991, 1993
        The Regents of the University of California.  All rights reserved.
Copyright (c) 1995-2007 OpenBSD. All rights reserved.  http://www.OpenBSD.org

OpenBSD 4.2 (GENERIC) #1517: Tue Aug 28 10:42:20 MDT 2007
    deraadt@macppc.openbsd.org:/usr/src/sys/arch/macppc/compile/GENERIC
real mem = 201326592 (192MB)
avail mem = 182444032 (173MB)
mainbus0 at root: model PowerBook3,1
cpu0 at mainbus0: 750 (Revision 0x8300): 400 MHz: 1MB backside cache
memc0 at mainbus0: uni-n
kiic0 at memc0 offset 0xf8001000
iic0 at kiic0
mpcpcibr0 at mainbus0 pci: uni-north, Revision 0xff
pci0 at mpcpcibr0 bus 0
pchb0 at pci0 dev 11 function 0 "Apple Uni-N AGP" rev 0x00
vgafb0 at pci0 dev 16 function 0 "ATI Mobility M3" rev 0x02, mmio
wsdisplay0 at vgafb0 mux 1: console (std, vt100 emulation)
mpcpcibr1 at mainbus0 pci: uni-north, Revision 0x0
pci1 at mpcpcibr1 bus 0
pchb1 at pci1 dev 11 function 0 "Apple Uni-N" rev 0x00
macobio0 at pci1 dev 23 function 0 "Apple Keylargo" rev 0x02
openpic0 at macobio0 offset 0x40000: version 0x4614 little endian
macgpio0 at macobio0 offset 0x50
macgpio1 at macgpio0 irq 47
"programmer-switch" at macgpio0 not configured
"escc-legacy" at macobio0 offset 0x12000 not configured
zsc0 at macobio0 offset 0x13000: irq 22,23
zstty0 at zsc0 channel 0
zstty1 at zsc0 channel 1
awacs0 at macobio0 offset 0x14000: irq 24,9,10 speaker
audio0 at awacs0
"timer" at macobio0 offset 0x15000 not configured
adb0 at macobio0 offset 0x16000 irq 25: via-pmu, 3 targets
akbd0 at adb0 addr 2: iBook keyboard with inverted T (ISO layout)
wskbd0 at akbd0: console keyboard, using wsdisplay0
ams0 at adb0 addr 3: EMP trackpad <tpad> 2-button, 400 dpi
wsmouse0 at ams0 mux 0
abtn0 at adb0 addr 7: brightness/volume/eject buttons
apm0 at adb0: battery flags 0x5, 99% charged
"battery" at macobio0 offset 0x0 not configured
"backlight" at macobio0 offset 0xf300 not configured
kiic1 at macobio0 offset 0x18000
iic1 at kiic1
wdc0 at macobio0 offset 0x1f000 irq 19: DMA
wd0 at wdc0 channel 0 drive 0: <IBM-DARA-206000>
wd0: 16-sector PIO, LBA, 5729MB, 11733120 sectors
wd0(wdc0:0:0): using PIO mode 4, DMA mode 2, Ultra-DMA mode 4
ohci0 at pci1 dev 24 function 0 "Apple USB" rev 0x00: irq 27, version 1.0
ohci1 at pci1 dev 25 function 0 "Apple USB" rev 0x00: irq 28, version 1.0
cbb0 at pci1 dev 26 function 0 "TI PCI1211 CardBus" rev 0x00: irq 58
usb0 at ohci0: USB revision 1.0
uhub0 at usb0: Apple OHCI root hub, rev 1.00/1.00, addr 1
usb1 at ohci1: USB revision 1.0
uhub1 at usb1: Apple OHCI root hub, rev 1.00/1.00, addr 1
cardslot0 at cbb0 slot 0 flags 0
cardbus0 at cardslot0: bus 1 device 0 cacheline 0x8, lattimer 0x20
pcmcia0 at cardslot0
mpcpcibr2 at mainbus0 pci: uni-north, Revision 0x16
pci2 at mpcpcibr2 bus 0
pchb2 at pci2 dev 11 function 0 "Apple Uni-N Eth" rev 0x00
"Apple Uni-N Eth Firewire" rev 0x01 at pci2 dev 14 function 0 not configured
gem0 at pci2 dev 15 function 0 "Apple Uni-N GMAC" rev 0x01: irq 41, address \
00:30:65:68:36:bc bmtphy0 at gem0 phy 0: BCM5201 10/100 PHY, rev. 2
bootpath: /pci@f2000000/mac-io@17/ata-4@1f000/disk@0:/bsd
root on wd0a swap on wd0b dump on wd0b
tra-DMA mode 4


[prev in list] [next in list] [prev in thread] [next in thread]