[prev in list] [next in list] [prev in thread] [next in thread] 

List:       nanog
Subject:    Re: Cisco switch LACP + 802.1q
From:       Randy Carpenter <rcarpen () network1 ! net>
Date:       2011-09-29 19:52:03
Message-ID: 6ccf3b9f-5043-402a-bfa3-e0ebcb75a45a () zimbra ! network1 ! net
[Download RAW message or body]


Thanks for all the suggestions.

I added the "switchport mode trunk" to the interfaces, and it did start working \
properly after a reload of the switch. Before the reboot, it would not work.

-Randy


----- Original Message -----
> 
> I am tearing my hair out with an issue, and I hope someone can point
> something out to me that I am missing.
> 
> I am setting up 2-port LACP sets on a Cisco 2960G-24TS-L, which then
> need to be 802.1q trunk ports.
> 
> I have set it up as follows:
> 
> interface Port-channel1
> switchport mode trunk
> !
> interface Port-channel2
> switchport mode trunk
> !
> interface Port-channel3
> switchport mode trunk
> !
> interface Port-channel4
> switchport mode trunk
> !
> interface GigabitEthernet0/1
> channel-protocol lacp
> channel-group 1 mode active
> !
> interface GigabitEthernet0/2
> channel-protocol lacp
> channel-group 1 mode active
> !
> interface GigabitEthernet0/3
> channel-protocol lacp
> channel-group 2 mode active
> !
> interface GigabitEthernet0/4
> channel-protocol lacp
> channel-group 2 mode active
> !
> interface GigabitEthernet0/5
> channel-protocol lacp
> channel-group 3 mode active
> !
> interface GigabitEthernet0/6
> channel-protocol lacp
> channel-group 3 mode active
> !
> interface GigabitEthernet0/7
> switchport mode trunk
> channel-protocol lacp
> channel-group 4 mode active
> !
> interface GigabitEthernet0/8
> switchport mode trunk
> channel-protocol lacp
> channel-group 4 mode active
> 
> 
> The problem is that after some period of time (sometimes minutes,
> sometimes hours), port-channel1 loses the "switchport mode trunk"
> 
> It just disappears from the config.  If I try to put it back, it adds
> "switchport mode trunk" to the member ports (Gi0/1, Gi0/2) as well,
> which does not work. I have to tear it all out and start again. It
> will then work for a while again.
> 
> port-channel2 and port-channel3 are not in use yet, but port-channel4
> is, and works just fine.
> 
> It is running IOS 15.0(1)SE. It was running 12.2 before, and it was
> doing the same thing, so I upgraded it to the latest available.
> 
> What could be the issue?
> 
> thanks,
> -Randy
> 


[prev in list] [next in list] [prev in thread] [next in thread]