[prev in list] [next in list] [prev in thread] [next in thread]
List: ms-smartcardddk
Subject: Re: Multiprotocol smartcards
From: Doug Barlow <dbarlow () MICROSOFT ! COM>
Date: 1998-08-27 15:01:35
[Download RAW message or body]
According to ISO, the protocol must be negotiated immediately following
reset, and remains in effect until the next reset. You can't change the
protocol without a reset.
Doug
-----Original Message-----
From: Thomas Bründl [SMTP:Thomas.Bruendl@UTIMACO.CO.AT]
Sent: Thursday, August 27, 1998 1:03 AM
To: SmartCardDDK@DISCUSS.MICROSOFT.COM
Subject: Multiprotocol smartcards
I have a general question about multiprotocol smartcards (e.g.G&D
test
card)
After a cold reset I select T=0.
Now I want to select T=1 protocol without a reset.
Is that possible ? What should the driver return ?
I think the behaviour should be the same if I first select T=1 and
T=0
without a reset.Correct?
Best regards
Thomas
--
Thomas Bruendl
Utimaco Safe Concept GmbH
Europaplatz 6
A-4020 Linz, Austria
Tel: ++43 (0)732 655 755 - 32
Fax: ++43 (0)732 655 755 - 5
E-Mail: Thomas.Bruendl@utimaco.co.at
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic