[prev in list] [next in list] [prev in thread] [next in thread]
List: mrtg
Subject: Re: [mrtg] No data in RRD file, but MRTG runs fine
From: Steve Shipway <s.shipway () auckland ! ac ! nz>
Date: 2010-05-08 21:51:19
Message-ID: 6B587E8C999646469B54486AF219584612DD724F62 () UXCHANGE7-1 ! UoA ! auckland ! ac ! nz
[Download RAW message or body]
You need to check to see if any error messages or diagnostics come when MRTG runs its \
poll. This will indicate if the SNMP poll is failing for some reason.
The MaxBytes is an upper limit of valid data (the default lower limit is 0); if your \
poll retrieves more than this value, the data will be stored as Unknown as well, so \
check your actual values against MaxBytes and make sure youve picked the right value.
Steve
________________________________________
From: Christian Ludwig [cludwig@net.t-labs.tu-berlin.de]
Sent: Sunday, 9 May 2010 9:35 a.m.
To: Steve Shipway
Cc: mrtg@lists.oetiker.ch
Subject: RE: [mrtg] No data in RRD file, but MRTG runs fine
Hello,
I do not get the data out of the polls at any time. Deleting the RRD
file was just an idea to rule out file corruption.
Even after 2 days I do not get any data. And this only happens for that
single target. All other targets behave as expected.
Just as an idea, does MaxBytes influence anything in the RRD?
- Christian
--
In the beginning was the word
and the word was content-type: plain/text
_______________________________________________
mrtg mailing list
mrtg@lists.oetiker.ch
https://lists.oetiker.ch/cgi-bin/listinfo/mrtg
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic