[prev in list] [next in list] [prev in thread] [next in thread]
List: linuxbios
Subject: Re: [coreboot] Issues building a ROM for Toshiba Chromebook 2 (aka Swanky)
From: Matt DeVillier <matt.devillier () gmail ! com>
Date: 2016-02-27 1:43:21
Message-ID: 56D0FF39.1090404 () gmail ! com
[Download RAW message or body]
On 2/26/2016 5:48 PM, Julius Werner wrote:
> > > > 2) I've also seen mention of Servo, but I don't seen any such header on
> > > > my board. Looking at a photo of the Acer C720 here, it does look like
> > > > there's an oblong space with pads there, but that would be a hell of a
> > > > surface mounting job:
> > > > https://www.chromium.org/chromium-os/developer-information-for-chrome-os-devices/acer-c720-chromebook
> > > >
> Yes, you'll likely not get very far without a serial console, and the
> only way to get that is with a soldering iron. The good news is that
> you shouldn't need the full Servo header... just the two AP UART lines
> is enough (should be pin 16 and 17). You can find the whole Servo
> pinout at https://www.chromium.org/chromium-os/servo/chromium_os_yoshi_flex.tar.gz
thanks to Stefan and Aaron I've got a servo en route and arriving
Monday, hopefully will have some time early next week to get it setup
and start playing with it.
--
coreboot mailing list: coreboot@coreboot.org
http://www.coreboot.org/mailman/listinfo/coreboot
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic