[prev in list] [next in list] [prev in thread] [next in thread]
List: linux-wlan-devel
Subject: Re: [lwlan-devel] "Allocate(tx) command failed" with wlan-ng-0.1.13
From: David Blythe <blythe () broadon ! com>
Date: 2002-05-31 2:08:16
[Download RAW message or body]
its not prism2, its symbol. i think the orinico driver is your best bet
david
Michael St. Laurent wrote:
> The prism2_cs module is loading sucessfully but I'm getting the following
> errors in the messages file:
>
> cardmgr[667]: executing: './wlan-ng start wlan0'
> /etc/hotplug/net.agent: invoke ifup wlan0
> kernel: hfa384x_drvr_start: Allocate(tx) command failed.
> kernel: hfa384x_drvr_start: Failed, result=127
> kernel: prism2sta_ifstate: hfa384x_drvr_start() failed,result=127
> cardmgr[667]: + Failed to enable the device, resultcode=
> implementation_failure .
>
> I'm using a D-Link DWL-650H. I've heard conflicting reports about whether
> or not this card uses the prism2 chipset. I've had some success using the
> orinoco module but it causes the card to lockup when under a heavy load so I
> thought I'd try the wlan-ng prism2 driver instead. Any help would be
> welcome.
>
>
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic