[prev in list] [next in list] [prev in thread] [next in thread]
List: linux-wireless
Subject: Re: [PATCH 01/11] rt2800: make rx ampdu_factor depend on number of rx chains
From: Kalle Valo <kvalo () codeaurora ! org>
Date: 2016-12-30 12:08:47
Message-ID: 87r34pk4a8.fsf () purkki ! adurom ! net
[Download RAW message or body]
Stanislaw Gruszka <sgruszka@redhat.com> writes:
> Initalize max ampdu_factor supported by us based on rx chains, vendor
> driver do the same.
>
> Signed-off-by: Stanislaw Gruszka <sgruszka@redhat.com>
When I was applying these patches I did an off by one error with my
patchwork script ('commit 2-12' vs 'commit 1-11') and accidentally
applied an orinoco patch to wireless-drivers-next along with these
rt2800 patches 1-10. I applied patch 11 separately and everything should
be in wireless-drivers-next now (as soon as I push it). But I would
appreciate if you could double check that everything is ok.
Sorry for the mess.
a08b98196a36 rt2800: make rx ampdu_factor depend on number of rx chains
e49abb19d1bf rt2800: don't set ht parameters for non-aggregated frames
a51b89698ccc rt2800: set minimum MPDU and PSDU lengths to sane values
8f03a7c6e7f9 rt2800: set MAX_PSDU len according to remote STAs capabilities
8845254112ac rt2800: rename adjust_freq_offset function
bc0077053948 rt2800: warn if doing VCO recalibration for unknow RF chip
24d42ef3b152 rt2800: perform VCO recalibration for RF5592 chip
d96324703ffa rt2x00: merge agc and vco works with link tuner
eb79a8fe94c8 rt2800: replace mdelay by usleep on vco calibration.
31369c323ba0 rt2800: replace msleep() with usleep_range() on channel switch
--
Kalle Valo
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic