[prev in list] [next in list] [prev in thread] [next in thread]
List: linux-smp
Subject: aha152x driver: SMP safe?!?
From: "Christopher E. Brown" <cbrown () Alaska ! NET>
Date: 1997-09-23 3:08:34
[Download RAW message or body]
Subject line says it all, since I upgraded to a SMP box I get
waiting: SCSISEQ (); SCSISIG (DATA OUT); INTSTAT (hi); SSTAT (BUSFREE );
SSTAT (BUSFREE ); SXFRCTL0 (CH1 ); SIGNAL (); SELID (8b), SSTAT2 (SEMPTY
);
SFCNT (0);
SCSICNT (0), OFFCNT(0), SSTAT4 (); DMACNTRL0 (16BIT PIO READ INTEN );
DMASTAT (DFIFOEMP )
enabled interrupts (ENBUSFREE )
scsi : aborting command due to timeout : pid 4, scsi0, channel 0, id 4,
lun
0 Test Unit Ready 00 00 00 00 00
aha152x: abort(), SCpnt=0x00091018, QUEUE STATUS:
issue_SC:
0x00091018: target=4; lun=0; cmnd=(Test Unit Ready 00 00 00 00 00
); residual=256; buffers=0; phase |not issued|; next=0x00000000
current_SC:
none
disconnected_SC:
One message for each id, 1 through 7 but the Jaz is never found. After
all seven messages system starts normally, only without the SCSI stuff.
System is a
P6DNF Rev 1.2 BIOS NA7081
PPro200/256K x 2 Stepping 9
Adaptec based 'Zip Zoom' card at 0x140,12
External Jaz, id:4 on supplied cable. Only SCSI device.
Thanks
----------------------------------------------------------------------------
Christopher E. Brown (CB421) <cbrown@alaska.net> +(907) 357-5680
Of course my password is the same as my pet's name.
My fish's name is Zm#7^DC!, but I change it once a week.
----------------------------------------------------------------------------
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic