[prev in list] [next in list] [prev in thread] [next in thread]
List: linux-smp
Subject: Re: Hardware: P6DNF configuration?
From: Bodo Junglas <junglas () uni-muenster ! de>
Date: 1997-06-30 10:38:09
[Download RAW message or body]
On Sun, 29 Jun 1997, Edward Welbon wrote:
> This may give you a clue. On a P6DOF board, the jumpers have these
> settings:
>
> J47 J48 J49 BUS
> -----------------------
> [...]
>
> J65 J64 J63 J63 RATIO
> -------------------------
> [...]
So far I interprete the P6DNF manual, we only have a total of six jumpers
handling the CPU/PCI-clocks ( J29,J30,J31,J32,J36,J37 )
More precise:
The Manual says
J29 J30 J31 J32 J36 J37
off on on on on off 150 Mhz CPU(s)
off on on on off on 166 Mhz CPU(s)
on off on on on off 180 Mhz CPU(s)
on off on on off on 200 Mhz CPU(s)
THE FOLLOWING IS MERELY MY GUESS!
IF YOU TRY YOU'RE EXPERIMENTING ON YOUR OWN RISC (MOTHERBOARD/CPU(s)):
I would say that at least J36, J37 regulate the PCI-clock (60 Mhz, 66 Mhz?)
and J29, J30 the CPU-ratio (2.5:1, 3:1 ?)
Extrapolating I assume that J31 and J32 also belong to CPU-ratio. You
might first leave the PCI-clock at 60 Mhz (or below, if possible) and
find out the right combination for 2:1 (if it exists) after this you can
freely experiment with the PCI-clock.
If you want to be sure you better contact someone at SuperMicro.
============================================================================
Bodo Junglas Phone: +49-251-83-34917 (be warned: It's very old)
Institut fuer E-Mail: junglas@uni-muenster.de
Theoretische Physik I or: junglas@poincare.uni-muenster.de
Wilhelm-Klemm-Str. 9 junglas@chaotix.uni-muenster.de
48149 Muenster, Germany WWW : http://planck.uni-muenster.de:8080/~junglas
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic