[prev in list] [next in list] [prev in thread] [next in thread]
List: linux-kernel
Subject: Adaptec 2940UW problem with 2.1.115 (and 2.0.35)
From: Mark Levitt <markl () citrix ! com>
Date: 1998-08-12 14:08:40
[Download RAW message or body]
I recently upgraded a RedHat 5.1 system from 2.0.34 to 2.0.35.
On boot, the SCSI driver gets to the point where it prints:
scsi0(0:-1:-1): Scanning channel for devices
Then it prints
scsi0(0:0:0) Parity error during phase Message-In.
After that, it begins attempting to reset the SCSI host and the SCSI bus
without success.
This exact same hardware worked fine with kernel 2.0.34. I have the machine
set up to dual boot with the earlier kernel and it comes up fine.
The Adaptec controller has a BIOS v1.22S
There are three devices: two Seagate drives and a CD-ROM (NEC I think.)
___________________________________________________________
Mark Levitt Not reading coffee in cup A:
Technical Writer Abort, Retry, Panic?
Citrix Systems
http://www.citrix.com
___________________________________________________________
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.altern.org/andrebalsa/doc/lkml-faq.html
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic