[prev in list] [next in list] [prev in thread] [next in thread]
List: linux-ha
Subject: Re: [Linux-HA] IP Takeover Question
From: Mark Watts <m.watts () eris ! qinetiq ! com>
Date: 2004-01-26 15:33:43
Message-ID: 200401261533.43640.m.watts () eris ! qinetiq ! com
[Download RAW message or body]
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
> Hi,
>
> I am about to set up A 2 Node Linux Cluster using linux-ha software.
> It works pretty fine so far.
>
> My configuration looks like this:
>
> 2 Nodes, each having two 2 Port Ethernet Cards.
> 1 Port of each Card is used for hearbeat.
>
> and 1 Port used for the services. The failover between the nodes works
> pretty fine, but when I unplug the active service ethernet port nothing
> happens. What do I have to do to make the system first of all switch the
> service ip to the remaining ethernet port and then if this also fails
> later and the first port is not back until then switch to the standby
> cluster node?
>
> I havent found any information about this.
>
> Thank you very much!
By default, since heartbeat can still communicate through its own interface,
it doesn't think anything is wrong.
I believe you should be using ipfail to do what you want.
Mark.
- --
Mark Watts
Senior Systems Engineer
QinetiQ TIM
St Andrews Road, Malvern
GPG Public Key ID: 455420ED
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.3 (GNU/Linux)
iD8DBQFAFTNXBn4EFUVUIO0RAjPnAKDPhvOR/kXaDI4oxoIGwum0gS+BhwCeKpDz
scLgCUsTG9wmzncUA/jUyRU=
=AXdY
-----END PGP SIGNATURE-----
_______________________________________________
Linux-HA mailing list
Linux-HA@lists.linux-ha.org
http://lists.linux-ha.org/mailman/listinfo/linux-ha
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic