[prev in list] [next in list] [prev in thread] [next in thread]
List: linux-dvb
Subject: Re: [linux-dvb] Pinnacle PCTV Sat HDTV Pro USB (PCTV452e)
From: Manu Abraham <abraham.manu () gmail ! com>
Date: 2007-10-30 22:52:21
Message-ID: 4727B5A5.2090202 () gmail ! com
[Download RAW message or body]
Dominik Kuhlen wrote:
> On Wednesday 24 October 2007 01:42, garlicdevel@ntlworld.com wrote:
> > at this point the results are the same (meter lights up but not much else)
> > so I can't say if this is better or worse at this point
> > although I've noticed the LED is staying at orange when it should be going green \
> > in both cases, which suggests the GPIO register isn't being set when it should
> You can change the GPIO1 initialisation to 0x02 instead of 0x82.
> this will switch the led to green when the frontend gets open()'ed.
> To switch it back to orange insert
> stb0899_write_reg(state, STB0899_GPIO01CFG, 0x82);
> in the stb0899_sleep() function.
> (this should be somehow limited to the pctv452e as the GPIOs might
> have different meanings on other devices)
I have added in a generic post process interface to the driver you can simply
add in a config for your LED's and it will be handled, no need to hardcode it in.
Please check, whether it works for you.
Manu
_______________________________________________
linux-dvb mailing list
linux-dvb@linuxtv.org
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic