[prev in list] [next in list] [prev in thread] [next in thread]
List: linux-arm-kernel
Subject: Re: [GIT PULL 1/2] bcm2835-dt-next-2018-02-28
From: Florian Fainelli <f.fainelli () gmail ! com>
Date: 2018-02-28 23:35:49
Message-ID: 1c65dc88-901f-2ad7-0f45-5d2f53dc1048 () gmail ! com
[Download RAW message or body]
On 02/28/2018 01:39 PM, Eric Anholt wrote:
> Hi Florian,
>
> The following changes since commit 7928b2cbe55b2a410a0f5c1f154610059c57b1b2:
>
> Linux 4.16-rc1 (2018-02-11 15:04:29 -0800)
>
> are available in the Git repository at:
>
> git://github.com/anholt/linux tags/bcm2835-dt-next-2018-02-28
>
> for you to fetch changes up to bcc76c4014dce4e3834dbd5b7f6593cbcfbfebe0:
>
> ARM: dts: bcm2835-rpi-zero-w: Enable OTG mode (2018-02-26 15:02:23 -0800)
>
> ----------------------------------------------------------------
> This pull request adds automatic BT probing to the Pi Zero W, OTG mode
> for the Zero W, the GPIO expander on the Pi3, and fixes I2S probe
> (which is disabled by default, but often used downstream)
>
> ----------------------------------------------------------------
> Baruch Siach (2):
> ARM: dts: bcm2835: make the firmware node into a bus
> ARM: dts: bcm2837-rpi-3-b: add GPIO expander
>
> Henry Zhang (1):
> ARM: dts: bcm283x: Fix pin function of JTAG pins
>
> Stefan Wahren (5):
> dt-bindings: bcm283x: Fix register ranges of bcm2835-i2s
> ARM: dts: bcm283x: Fix probing of bcm2835-i2s
> ARM: dts: bcm283x: Apply pull settings to Zero W relevant groups
> ARM: dts: bcm2835-rpi-zero-w: Add bcm43438 serial slave
> ARM: dts: bcm2835-rpi-zero-w: Enable OTG mode
Merged into devicetree/next, thanks Eric!
--
Florian
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic