[prev in list] [next in list] [prev in thread] [next in thread]
List: kde-buildsystem
Subject: Re: cmake cvs supports chrpath -> much faster relinking
From: David Faure <faure () kde ! org>
Date: 2007-12-19 10:22:21
Message-ID: 200712191122.21518.faure () kde ! org
[Download RAW message or body]
On Wednesday 19 December 2007, Stephan Kulow wrote:
> Am Mittwoch 19 Dezember 2007 schrieb David Faure:
> > On Tuesday 18 December 2007, Alexander Neundorf wrote:
> > > Hi,
> > >
> > > I just committed support for chrpath to cmake cvs.
> > > chrpath can modify the RPATH inside an ELF file. This means that on make
> > > install, the executables don't have to be actually linked again, but
> > > instead they are installed as they are and then chrpath is run on them.
> > > This reduces this additional relinking time almost to zero.
> > >
> > > To use it you need:
> > > current kdesupport (-> so chrpath gets installed)
> > > current cmake cvs
> >
> > Funny; if cmake cvs can call chrpath, why isn't chrpath part of cmake?
>
> That question applies to binutils and gcc too - it should only be required to
> install cmake, nothing else, to build KDE ;-)
Hmm, OK... chrpath can also be useful to people not using cmake, I see.
--
David Faure, faure@kde.org, sponsored by Trolltech to work on KDE,
Konqueror (http://www.konqueror.org), and KOffice (http://www.koffice.org).
_______________________________________________
Kde-buildsystem mailing list
Kde-buildsystem@kde.org
https://mail.kde.org/mailman/listinfo/kde-buildsystem
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic