[prev in list] [next in list] [prev in thread] [next in thread]
List: juniper-nsp
Subject: Re: [j-nsp] Load Balancing IPv6 Traffic Flows
From: "Stefan Fouant" <sfouant () gmail ! com>
Date: 2008-05-20 20:36:29
Message-ID: 2bbf8c3f0805201336y48bf4bc1wb66899af57762645 () mail ! gmail ! com
[Download RAW message or body]
Whoot! You guys are awesome!
sfouant@rtrxxxx-re1# run show route forwarding-table destination
2001:xxx:dead:beef::/48
Routing table: inet6
Internet6:
Destination Type RtRef Next hop Type Index NhRef Netif
2001:xxx:dead:beef::/48 user 0 ulst 1048589 4
indr 1048582 8
2001:xxx:xxxx::3 ucst 552 4 ge-2/3/0.0
indr 1048577 4
2001:xxx:xxxx::20 ucst 553 4 ge-2/3/0.0
Thanks,
Stefan Fouant
Principal Network Engineer
NeuStar, Inc. - http://www.neustar.biz
On Tue, May 20, 2008 at 4:20 PM, Daniel Verlouw <daniel@bit.nl> wrote:
> On May 20, 2008, at 9:57 PM, Stefan Fouant wrote:
>>
>> I'm wondering if anyone else has seen any similar problems and are
>> there any gotchya's when configuring load-balancing for IPv6 traffic.
>
>
> you cannot match on family inet and inet6 in one term, 8.5 returns the
> following error:
>
> [edit policy-options]
> daniel@jun1-test.galilei# commit check
> [edit]
> 'policy-options'
> Policy error: Policy-statement load-balance, term prefixes: unable to
> merge prefix-list v6_routes because of different address family
> error: configuration check-out failed
>
> You need to split your policy into two separate terms, one matching on
> family inet and the other on family inet6, e.g.:
>
> [edit policy-options policy-statement load-balance]
> daniel@jun1-lab# show
> term v4_prefixes {
> from {
> prefix-list-filter v4_routes orlonger;
> }
> then {
> load-balance per-packet;
> }
> }
> term v6_prefixes {
> from {
> family inet6;
> prefix-list-filter v6_routes orlonger;
> }
> then {
> load-balance per-packet;
> }
> }
>
> Hope this helps.
>
> --Daniel.
>
_______________________________________________
juniper-nsp mailing list juniper-nsp@puck.nether.net
https://puck.nether.net/mailman/listinfo/juniper-nsp
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic