[prev in list] [next in list] [prev in thread] [next in thread]
List: ipfire-development
Subject: Re: Problem building perl on ipfire 2.x on Ubuntu 64 bit...Another try two years later
From: Matthias Fischer <matthias.fischer () ipfire ! org>
Date: 2017-08-16 15:48:36
Message-ID: 2c19a35a-60a8-f57c-9407-ff7dffcfdc41 () ipfire ! org
[Download RAW message or body]
On 16.08.2017 16:59, Michael Tremer wrote:
> Hi,
>
> On Wed, 2017-08-16 at 09:47 -0400, William Pechter wrote:
>> Michael Tremer wrote:
>> > Hello,
>> >
>> > are you trying to build the toolchain here?
>> >
>> > If so, you can just download a pre-compiled one with:
>> >
>> > ./make.sh gettoolchain
>> >
>> > Sometimes it is a bit tricky to compile them on various host
>> > systems.
>> >
>> > Best,
>> > -Michael
>> >
>> > On Wed, 2017-08-09 at 19:24 -0400, William Pechter wrote:
>> > \
>> > > A couple of years ago I reported the issue but had to drop it due
>> > > to
>> > > a
>> > > lack of time on my part.
>> > >
>> > > Perl 5.12.3 fails to build on my Ubuntu 17.04 system (was
>> > > upgraded
>> > > from
>> > > the 14.04 I was using a couple of years ago.
>> > > perl [ 5.12.3
>> > > ] [ 92
>> > > ] [
>> > > FAIL ]
>> > >
>>
>> I tried it both ways. No luck. Building 32 bit under 32 bit CentOS
>> works fine.
>> I'm going to try again on a clean 17.04 install.
>
> Yes, I am using Fedora on my machine, too and that works fine.
>
> I just don't understand why Ubuntu is different.
>
> Anybody else using Ubuntu?
Yes. Me. Ubuntu 16.04.3 LTS. Since the beginning. No problems so far.
;-)
Best,
Matthias
>
> -Michael
>
>>
>> Bill
>>
>
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic