[prev in list] [next in list] [prev in thread] [next in thread]
List: haiku-bugs
Subject: [haiku-bugs] Re: [Haiku] #5859: "shutdown -q" fails in terminal
From: "bonefish" <trac () haiku-os ! org>
Date: 2010-04-30 21:42:32
Message-ID: 052.585aefa8677eda6a4d65976f0809f470 () haiku-os ! org
[Download RAW message or body]
#5859: "shutdown -q" fails in terminal
-----------------------+----------------------------------------------------
Reporter: Disreali | Owner: nobody
Type: bug | Status: new
Priority: normal | Milestone: R1
Component: - General | Version: R1/Development
Keywords: | Blockedby:
Platform: All | Blocking:
-----------------------+----------------------------------------------------
Comment(by bonefish):
Replying to [comment:3 Disreali]:
> Replying to [comment:2 axeld]:
> > Generally, powering off can only work if APM or ACPI has been enabled
- did you do that? It's not enabled by default in that revision yet (only
after r36474).
>
> One of the first things I do after any install is to enable ACPI.
Though, I do not enable APM. Is that needed also?
No, enabling both is calling for trouble.
> I tried to upload my syslog, but it was to big. I don't know what I
should be looking for in the syslog. If someone could give me an idea, I
could then upload that section.
Please note that the syslog can contain output of several sessions. One is
fully sufficient. You can e.g. search for a line "Welcome to the Haiku
boot loader!". The output for the session starts about 20 lines above that
with a line "options = 0". Normally the output for a single session
shouldn't hit the attachment size limit. If it still does, please zip it
(gzip, bzip2, zip,...).
> Also, I just found out that if I enter 'shutdown' without any switch, it
will shutdown the system. This is not expected behavior. Entering
'shutdown' without a switch should print out the same as 'shutdown -h'.
The current behavior is definitely the expected one. All commands that
don't need arguments should have a reasonable default behavior when
invoked without any. And it is kind of obvious what the default behavior
of the ''shutdown'' command would be.
Replying to [comment:4 Disreali]:
> Just installed r36511-alpha-rc and entering 'shutdown -q' in terminal
freezes the system. System does not respond to keyboard or mouse input,
and I have to do a hard reset.
>
> Would you prefer I enter a new ticket for this?
Yes please. Also check whether you can still enter the kernel debugger
(Alt-Sysreq-D).
--
Ticket URL: <http://dev.haiku-os.org/ticket/5859#comment:5>
Haiku <http://dev.haiku-os.org>
Haiku - the operating system.
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic