[prev in list] [next in list] [prev in thread] [next in thread]
List: grass-user
Subject: Re: [GRASS-user] v.vol.rst - not enough disk space to write temp file
From: Markus Neteler <neteler () osgeo ! org>
Date: 2018-12-27 12:24:43
Message-ID: CALFmHhv-1G4S3hOQJS3jdLHKjqHyH7QKJZ+vbX5Lq8UCN9jmCA () mail ! gmail ! com
[Download RAW message or body]
On Thu, Dec 20, 2018 at 2:42 AM Francois Chartier
<fra.chartier@gmail.com> wrote:
> Hi,
>
> trying to run v.vol.rst with a larger dataset but using a smaller footprint for the \
> interpolation, using the same domain than my previous dataset. The interpolation \
> does not reach the end of the simulation as there is not enough disk space. Any \
> way around this?
... get more disk space :-)
> (Wed Dec 19 20:24:48 2018)
> v.vol.rst --overwrite input=GeomodDec16@Toronto wcolumn=dbl_2 tension=100 \
> elevation=trialdec16 280957 records selected from table
> WARNING: Some points outside of region -- will ignore...
> WARNING: Strip exists with insufficient data
> Processing all selected output files will require 1830391004 bytes of disk space \
> for temp files
> WARNING: There are points outside specified 2D/3D region--ignored 222354 points \
> (total points: 280957)
> WARNING: Points are more dense than specified 'DMIN'--ignored 1946 points (remain \
> 279011)
> WARNING: Unable to create <(null)> raster map without cross_input raster map being \
> specified
(note: this <(null)> in that message I have fixed now but it is
unrelated to the problem).
> ERROR: Not enough disk space - cannot write temp files
When running the command keep an eye on the disk space: perhaps it
writes the temp files to a very small partition?
> (Wed Dec 19 20:29:56 2018) Command finished (5 min 8 sec)
>
> g.region -3p [i have set a number of rows and columns to 100 for each, and \
> res3.value as 1 (not sure if this contradict the number of column \
> and rows)
> projection: 1 (UTM)
> zone: 17
> datum: nad83
> ellipsoid: grs80
> north: 4862000
> south: 4846000
> west: 609200
> east: 651700
> top: 250.00000000
> bottom: 50.00000000
> nsres: 160
> nsres3: 0.11358232
> ewres: 425
> ewres3: 0.44870509
nsres3 and ewres3 are not equal, is that intended?
> tbres: 2
> rows: 100
> rows3: 140867
> cols: 100
> cols3: 94717
> depths: 100
> cells: 10000
> cells3: 1334249963900
This is a fairly large amount of voxels: 1.33425e+12
Likely the need for much temp space stems from that.
Markus
_______________________________________________
grass-user mailing list
grass-user@lists.osgeo.org
https://lists.osgeo.org/mailman/listinfo/grass-user
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic