[prev in list] [next in list] [prev in thread] [next in thread]
List: gimp-print-devel
Subject: Re: [Gimp-print-devel] Support for north American Epson Ecotank printers
From: Robert Krawitz <rlk () alum ! mit ! edu>
Date: 2018-03-01 2:06:11
Message-ID: 20180301020611.DEFDB141AFC () localhost
[Download RAW message or body]
On Wed, 28 Feb 2018 10:08:33 -0600, Alex G wrote:
> On 02/28/2018 07:03 AM, Robert Krawitz wrote:
> > On Sun, 18 Feb 2018 15:59:46 -0600, Alex G wrote:
> > > I have been trying several variations of remote/init sequence and the likes, \
> > > and I seem to be getting consistent results (AKA empty paper spat out). Is \
> > > there some better method to crack this than blind trial and error?
> >
> > This usually means you're using parameters incompatible with the
> > printer (usually wrong nozzle spacing or number of nozzles in the
> > corresponding commands). I don't know what you're trying in terms of
> > the base printer you're using or anything, so it's hard for me to
> > comment.
>
> I think I tried L120, and some other Stylus models with CMYK inks.
>
> > Printing a test page from the printer's front panel will usually
> > reveal how many nozzles there are and their spacing.
>
> K: 400 nozzles over 1.3 in
> CMY: 128 nozzles over 0.42 in
>
> You're right about the 300 dpi spacing.
It's good to know those specs, at least.
--
Robert Krawitz <rlk@alum.mit.edu>
*** MIT Engineers A Proud Tradition http://mitathletics.com ***
Member of the League for Programming Freedom -- http://ProgFree.org
Project lead for Gutenprint -- http://gimp-print.sourceforge.net
"Linux doesn't dictate how I work, I dictate how Linux works."
--Eric Crampton
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Gimp-print-devel mailing list
Gimp-print-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/gimp-print-devel
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic