[prev in list] [next in list] [prev in thread] [next in thread]
List: gentoo-ppc-user
Subject: Re: [gentoo-ppc-user] Install on a Power5 (p5 550)
From: Michael Stilson Jr <michael.stilson () wmich ! edu>
Date: 2006-11-09 19:08:09
Message-ID: 45537C99.3060100 () wmich ! edu
[Download RAW message or body]
Ovidiu Bivolaru wrote:
> I think root is /dev/sda3.
agreed. most excellent eyes ovidiu, i totally overlooked it the first
time i read through this message. :)
rodrigo, please change the "root" and "append" param values from:
>> root = /dev/sda1
>> append="root=/dev/sda1"
to
root = /dev/sda3
append="root=/dev/sda3"
and see if that fixes the current hang up.
good luck
> Rodrigo Monteiro wrote:
>> Hello all!
>>
>> I'm new to this world: PowerPC, RISC, 64 bits.
>> So, it's a newbie doubt...
>>
>> I'm following this manual
>> http://www.gentoo.org/doc/en/handbook/2006.0/handbook-ppc64.xml?full=1#book_part1
>>
>> My question it's about the yaboot and the partitions type.
>> /dev/sda1: PReP (8MB)
>> /dev/sda2: swap (1GB)
>> /dev/sda3: / (30GB)
>>
>> Questions:
>> 1) What is an PReP partition?
>> 2) How should be my /etc/yaboot.conf like?
>> Mine was like "Code Listing 6: yaboot.conf for PReP hardware"
>> default = linux
>> timeout = 100
>> image=/boot/kernel-2.6.12-gentoo-r10
>> label=linux
>> read-only
>> root = /dev/sda1
>> append="root=/dev/sda1"
>> Is it correct?
>> Guess not, beacuse after it boots up, crashe and restart.
>> What am I doing wrong?
>>
>> If you need more information, please ask. I don't know what to say
>> more :)
>>
>> Thanks,
>> Rodrigo.
>
--
gentoo-ppc-user@gentoo.org mailing list
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic