[prev in list] [next in list] [prev in thread] [next in thread]
List: gdb
Subject: RE: how to build gdb with cygnus?
From: <kbs () swc ! sec ! samsung ! co ! kr>
Date: 1999-04-20 3:37:19
Message-ID: 003928C86BDDD211BC8000A0C98A6129031752 () SWC
[Download RAW message or body]
Thank you very much.
It worked as you said.
best regards,
Bumsoo Kim
kbs@swc.sec.samsung.co.kr
> -----Original Message-----
> From: fortinj@ibm.net [SMTP:fortinj@ibm.net]
> Sent: Monday, April 12, 1999 9:18 PM
> To: PARK JONG PORK
$)C
> Cc: !>e)vu(yo; gdb@cygnus.com
> Subject: Re: how to build gdb with cygnus?
>
> What I did is went into each directory individually and ran configure.
> Some of them didn't work correctly, some of them did. I then copied the
> largest config.cache without errors to the base directory and ran
> configure again. I believe I had one or two small errors, but ignored
> them. I checked the config.cache after the errors and the correct
> values were there. I don't remember which they were.
>
> gdb then compiled, though without thread support.
>
> regards,
> John Fortin
> fortinj@ibm.net
>
> PARK JONG PORK wrote:
> >
> > I had same problem.
> > and, new snapshot(04/xx) can't compile Perl 5.005_03 better.
> >
> > ----- "/)*(,!m ",(-(vAAo -----
> > (,",)x(v !mc"R!@: !>e)vu(yo <kbs@swc.sec.samsung.co.kr>
> > )v(-"%A !mc"R!@: <gdb@cygnus.com>
> > (,",)x(v )x?A!M: 1999)xa 4"/u 12AI "/u"/aAI "/AEA 3:46
> > A|",n: how to build gdb with cygnus?
> >
> > > John Fortin told us:
> > >
> > > > All, I compiled the newest snapshot of gdb using cygwin ( after
> > > fighting
> > > > with the configuration. Doesn't seem to work well recursively. )
> > >
> > > I have the same problem with gdb-4.17 and gdb-4.18.
> > > Could you tell me how you worked it out?
> > >
> > > Thanks,
> > > Bumsoo Kim
> > > kbs@swc.sec.samsung.co.kr
> > >
> > >
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic