[prev in list] [next in list] [prev in thread] [next in thread]
List: freeradius-users
Subject: Re: RadPerf
From: Alan DeKok <aland () deployingradius ! com>
Date: 2018-07-30 15:50:33
Message-ID: 038B56D1-A067-475C-8A93-F514E0AA6E96 () deployingradius ! com
[Download RAW message or body]
On Jul 30, 2018, at 10:43 AM, Dean Smith <dean@eatworms.org.uk> wrote:
> For network load balancing reasons, I would like the radius packets to have
> a good spread of source ports. Radperf (version 1.1b) appears to use the
> same source port for each test run. I there a way to have it use a random
> port for each request?
No.
If it sends a lot of packets, it will open new source ports. But not a lot.
To do proper RADIUS load balancing, you should load balance on the contents of the \
RADIUS packets. Not on network ip/port.
Alan DeKok.
-
List info/subscribe/unsubscribe? See http://www.freeradius.org/list/users.html
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic