Daniel Houlbrooke wrote:

> I just tested this on a commercial NX 1.5 setup and it seems to draw things 
> correctly without the recompile. So if anyone has any ideas?!
> 
> Cheers,
> 

I installed an evaluation version of the commercial 1.5-nxserver 
(NXSERVER - Version 1.5.0-61 PE (Evaluation)), and it shows the same 
problem. It does not draw the icewm-generated parts correctly. The only 
difference is, that after terminating the session using "logout" in the 
icewm-menu the nxclient-window doesn't close with the commercial 
nxserver. With freeNX it closed. Seems like freeNX is slightly ahead of 
nomachines ;-).

andreas

-- 
________________________________________________

Andreas Wilde

Fraunhofer-Institut fuer Integrierte Schaltungen
Aussenstelle Entwurfsautomatisierung
Zeunerstr. 38
D-01069 Dresden

Tel.: 49 (0) 351 4640 852
Fax : 49 (0) 351 4640 703
E-Mail: Andreas.Wilde@eas.iis.fraunhofer.de
________________________________________________

_______________________________________________
FreeNX-kNX mailing list
FreeNX-kNX@kde.org
https://mail.kde.org/mailman/listinfo/freenx-knx