[prev in list] [next in list] [prev in thread] [next in thread] 

List:       freediameter-help
Subject:    [Help] freeDiameter app_test
From:       sdecugis () freediameter ! net (Sebastien Decugis)
Date:       2011-06-06 17:01:43
Message-ID: 4DED07F7.7070006 () freediameter ! net
[Download RAW message or body]

Hi,

Ok, it is good to know that it works now. Let's hope the problem does 
disappear :)

Best regards,

Sebastien.

Le 2011/06/06 12:20, ayaaash a ?crit :
> Hi,
>
> I tried to report the log and the message exchange to solve the 
> problem but it doesn't exist anymore. The servers are able to send and 
> echo the messages now. I don't know what was causing the segfault but 
> if it appeared again, I will let you know. Thank you for your help anyway.
>
> Regards,
>
> Ishfaq
>
> On Tue, May 31, 2011 at 10:32 AM, Sebastien Decugis 
> <sdecugis at freediameter.net <mailto:sdecugis at freediameter.net>> wrote:
>
>     Hi,
>
>     Can you provide the log of the daemons? Also, it would be very
>     useful to get more information on the segmentation fault, can you
>     provide the stack at the time of segfault (from gdb)?
>
>     If some watchdog messages are exchanged, I take it that the peers
>     remain in OPEN state for a while at least. During this time, are
>     you not able to send app_test messages ? Can you tell me what
>     happens when you send the SIGUSR1 signal to the daemon?
>
>     Regards,
>     Sebastien.
>
>     Le 2011/05/30 8:30, ayaaash a ?crit :
>>     Hi,
>>
>>     I have setup two computers and have configured freeDiameter on
>>     each of them. I am now using the app_test to send messages from
>>     one computer to the other, but somehow I am not able to send any
>>     messages through. The daemon is loaded with no problem in both
>>     the computers and the state also changes from CLOSE to OPEN, but
>>     then immediately goes back to CLOSE. Now I know that the app_test
>>     can't send messages unless the state is open but I want to figure
>>     out what I am doing wrong.
>>
>>     The monitor shows me that app_test hasn't sent any messages. 0
>>     Echoed, 0 sent and 0 Received. The daemon does capability
>>     exchange for a while after the state goes to close and afterwards
>>     does watchdog exchange too. The daemon, then closes on one of the
>>     peers because of a segmentation fault.
>>
>>     Thank your very much for your time and help.
>>
>>
>>     Regards,
>>
>>     Ishfaq
>>
>>
>>     _______________________________________________
>>     Help mailing list
>>     Help at freediameter.net  <mailto:Help at freediameter.net>
>>     http://lists.freediameter.net/cgi-bin/mailman/listinfo/help
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.freediameter.net/pipermail/help/attachments/20110606/944469c8/attachment.html>

[prev in list] [next in list] [prev in thread] [next in thread]