[prev in list] [next in list] [prev in thread] [next in thread]
List: freebsd-stable
Subject: hw.ata.wc setting and atacontrol cap output do not match ?
From: Ari Suutari <ari () suutari ! iki ! fi>
Date: 2003-01-30 10:19:57
[Download RAW message or body]
Hi,
I have put
hw.ata.wc="0"
to /boot/loader.conf on some of my machines.
After booting, sysctl shows:
# sysctl hw.ata.wc
hw.ata.wc: 0
However, atacontrol shows different results:
# atacontrol cap 0 0
ATA channel 0, Master, device ad0:
ATA/ATAPI revision 4
device model SAMSUNG SV1022D
Feature Support Enable Value Vendor
write cache yes yes
it reports that write cache is still ENABLED ?
I wonder if the output is just wrong or the cache is still
being used. If I perform an "atacontrol reinit" then
atacontrol cap starts to report write cache as disabled.
I would very much like to write cache to really
be off, since I have some machines running
at locations which tend to have power failures
from time to time.
Ari S.
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-stable" in the body of the message
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic