[prev in list] [next in list] [prev in thread] [next in thread]
List: freebsd-stable
Subject: Re: PPPoE: "session in wrong state"
From: Mike Tancsa <mike () sentex ! net>
Date: 2002-09-30 3:42:33
[Download RAW message or body]
Add
disable vjcomp
to your ppp.conf. In terms of your nic, ste0, is it set to half duplex
? Do you have another type of nic to try with ? I am not familiar with the
ste driver.
---Mike
At 11:28 PM 9/29/2002 -0400, William Denton wrote:
>On 29 September 2002, Mike Tancsa wrote:
>
>: Can you post your ppp config ?
>
>In ppp.conf I have:
>
> default:
> ident user-ppp VERSION (built COMPILATIONDATE)
> set log Phase Chat IPCP CCP tun command
> set ifaddr 10.0.0.1/0 10.0.0.2/0 255.255.255.0 0.0.0.0
>
> myisp:
> set device PPPoE:ste0
> set authname xxxx
> set authkey xxxx
> set dial
> set login
> add default HISADDR
>
>Then in rc.conf I start it with:
>
> ppp_enable="YES"
> ppp_mode="ddial"
> ppp_nat="YES"
> ppp_profile="myisp"
>
>: Also, do you have header compression enabled ? If so, some DSL
>: concentrators deployed by Bell do not play well at all with VJHeader
>: Compression enabled. Explicitly disable it.
>
>I didn't enable this (I didn't even know about it). I see
>
> options NETGRAPH_VJC
>
>in LINT, but didn't include this in my kernel config. Unless it's
>somewhere else, it's off.
>
>Thanks,
>
>Bill
>--
>William Denton : Toronto, Canada : http://www.miskatonic.org/ : Caveat lector.
>
>
>
>To Unsubscribe: send mail to majordomo@FreeBSD.org
>with "unsubscribe freebsd-stable" in the body of the message
--------------------------------------------------------------------
Mike Tancsa, tel +1 519 651 3400
Sentex Communications, mike@sentex.net
Providing Internet since 1994 www.sentex.net
Cambridge, Ontario Canada www.sentex.net/mike
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-stable" in the body of the message
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic