[prev in list] [next in list] [prev in thread] [next in thread] 

List:       freebsd-scsi
Subject:    Re: camcontrol sanitize
From:       "Kenneth D. Merry" <ken () FreeBSD ! ORG>
Date:       2017-07-27 15:22:07
Message-ID: 20170727152207.GA91629 () mithlond ! kdm ! org
[Download RAW message or body]

On Wed, Jul 26, 2017 at 12:57:40 +0500, Eugene M. Zheganin wrote:
> Hi,
> 
> 
> Today I wanted to wipe the all data from one of my disks, so I decided 
> to use camcontrol sanitize:
> 
> 
> # camcontrol sanitize 12:22:0 -a block
> You are about to REMOVE ALL DATA from the following device:
> pass16: <ATA TOSHIBA THNSN81Q 6101> Fixed Direct Access SPC-4 SCSI device
> pass16: Serial Number         96GS10T2TB4V
> pass16: 1200.000MB/s transfers, Command Queueing Enabled
> Are you SURE you want to do this? (yes/no) yes
> Current sanitize timeout is 10800 seconds
> Enter new timeout in seconds or press
> return to keep the current timeout [10800]
> camcontrol: Unexpected CAM status 0xe
> 
> 
> Looks like it failed to do what it should. Was it me issuing something 
> bad (while it's not obvious to me), some bug in SCSI subsystem or bad 
> equipment ?

CAM status 0xe is a bus reset.  Do you see anything in dmesg that might
shed more light on it?  If you use the -v switch, camcontrol will print out
more verbose error information, and should provide text for the error
number.

What kind of controller are you using?  I'm guessing you are using a 12Gb
SAS controller given what I see above.  What firmware revision is on the
controller?

The drive is a SATA drive, and SANITIZE is a SCSI command.  There are
translations defined in the SAT spec to translate SANITIZE to an ATA
command.  I don't know whether your controller supports those translations
or whether the drive supports the underlying ATA BLOCK ERASE EXT command.

Ken
-- 
Kenneth Merry
ken@FreeBSD.ORG
_______________________________________________
freebsd-scsi@freebsd.org mailing list
https://lists.freebsd.org/mailman/listinfo/freebsd-scsi
To unsubscribe, send any mail to "freebsd-scsi-unsubscribe@freebsd.org"
[prev in list] [next in list] [prev in thread] [next in thread] 

Configure | About | News | Add a list | Sponsored by KoreLogic