[prev in list] [next in list] [prev in thread] [next in thread]
List: freebsd-scsi
Subject: Re: Troubles with Adaptec 7902 Ultra320 controller
From: Nate Lawson <nate () root ! org>
Date: 2003-03-03 20:40:00
[Download RAW message or body]
On Fri, 28 Feb 2003, Steve Grandi wrote:
> On Tue, 25 Feb 2003, Steve Grandi wrote:
>
> > I've been trying to bring up Stable on a Supermicro X5DPR-8G2+ motherboard
> > which features an integrated Adaptec AIC-7902 dual channel Ultra 320
> > controller. Three disks are present, all on the A channel.
> >
> > 4.7-Release blows up badly on this hardware (starting with "ahd0: WARNING -
> > Failed chip reset! Trying to initialize anyway).
>
> To follow up my own post, I installed a 29160 in the system, installed
> 4.7-RELEASE, upgraded to STABLE, and then tried the on-board Ultra 320
> controller again. Lo and behold, the hang during disk probing no longer
> occurs and the system comes up and runs fine. However, the "card state
> dump" on the unused B channel of the 7902 (ahd1) still occurs. I wonder
> what would happen if there actually was a disk on the B channel?
My only guess is that this is a firmware problem that was fixed in 5.0.
isp(4) on the 2[12]00 had (has?) a similar problem where the firmware
would never finish a probe when there was no drive attached.
-Nate
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-scsi" in the body of the message
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic