[prev in list] [next in list] [prev in thread] [next in thread]
List: freebsd-current
Subject: Re: fxp0 failures on APCI/APM resume
From: "Daniel O'Connor" <doconnor () gsoft ! com ! au>
Date: 2002-08-30 1:47:55
[Download RAW message or body]
> The new apci & pci-pci code works wonderfully. However, I've got a
> problem with the fxp driver not reenabling the device correctly upon a
> resume from suspend. Details below - Note even when I try to put the
> laptop into suspend mode S2 which it doesn't support the problem
> occurs, the only solution is a reboot. Patches welcome.
>
> Aug 30 09:38:15 draco kernel: acpi0: AcpiGetSleepTypeData failed -
> AE_NOT_FOUND
> Aug 30 09:38:50 draco kernel: fxp0: chip is in D3 power mode -- setting
> to D0
> Aug 30 09:38:52 draco kernel: fxp0: SCB timeout: 0xff 0xff 0xff 0xffff
I've had this problem when I didn't have the fxp driver loaded before
suspending so it couldn't save the card state.
Not sure if it applies in your case but it's something to keep in mind -
espcially when testing new stuff where you might not load things as normal.
---
Daniel O'Connor software and network engineer
for Genesis Software - http://www.gsoft.com.au
"The nice thing about standards is that there
are so many of them to choose from."
-- Andrew Tanenbaum
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-current" in the body of the message
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic