[prev in list] [next in list] [prev in thread] [next in thread]
List: elecraft
Subject: Re: [Elecraft] Erratic KPA-1500 behavior
From: AJ8MH Radio <aj8mh-radio () charter ! net>
Date: 2024-03-27 15:37:19
Message-ID: c8bb3efa-fe3c-4100-aa3c-dc69798a8d6c () charter ! net
[Download RAW message or body]
I see some reports of K3 overshoot when changing bands or adjusting
drive. That would cause excessive drive. Performing the re-calibration
procedure may correct the problem.
On 3/27/2024 10:18 AM, Pete Smith N4ZR wrote:
> This morning, starting the CWT, every few transmissions my amp was
> faulting with the indication of excessive driving power (~67 watts vs
> 33 watts normally). Each time, it would fault once, then operate
> normally for a dozen or so transmissions before the next fault. Then,
> about 10 minutes into the hour, the faults stopped happening. The K-3
> showed 33 watts throughout
>
> I checked the KPA-1500 log, and all it shows is the "power input"
> fault. What could be causing this erroneous indication of excessive
> drive? A sticky relay?
>
--
Joe Hutchens
AJ8MH - Radio
Marquette, MI
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to elecraft@progressive-comp.com
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic