[prev in list] [next in list] [prev in thread] [next in thread]
List: elecraft
Subject: Re: [Elecraft] K3S and FT8
From: Bob McGraw K4TAX <rmcgraw () blomand ! net>
Date: 2017-09-27 13:31:48
Message-ID: e5588928-5fa6-cc50-3511-15fee32d792f () blomand ! net
[Download RAW message or body]
I'm using WSJT-X verson 1.8.0-rc2 with CAT control and having no
issues. Nothing exotic in my configuration, just using the single USB
cable between the laptop computer and the radio. I allow WSJT-X to log
the contact and then I export the generated ADI file to my LOTW and
QRZ.COM logs.
I've almost completed my WAS using FT-8 mode on 6 meters. Plus I've
worked a lot of DX on other bands. I find it is a fun, fast and very
easy mode to make contacts. Of course, if you are in to "rag
chewing", forget it. It is not a rag chew mode.
73
Bob, K4TAX
On 9/22/2017 2:48 AM, Richard Lamont wrote:
> On 31/07/17 20:19, Wes Stewart wrote:
>
>> I noted that when my transmit interval occurred, there seemed to be
>> about a one and a half second delay before the K3 began to transmit. I
>> began an exchange of email with Bill, G4WJS, about this issue. I quote
>> from one of his:
>>
>> "If you are seeing a 1.5s delay then that is because CAT commands sent
>> before PTT, even if PTT is "virtual" due to using VOX, are taking
>> roughly that long. The K3 series is problematic in that certain CAT
>> commands can take a long time to complete
> On 12/8/17, Bill G4WJS posted a message to the hamlib-developer list
> concerning a patch to k3.c to "Take out unnecessary delays in K(X)3(S)
> back end". This was incorporated into versions of hamlib subsequently
> distributed with WSJT-X. I've found that it greatly improved control of
> the K3S.
>
> So, use WSJT-X 1.8.0-rc2 or later, and use the version of
> hamlib/rigctl/rigctld distributed with it.
>
> 73,
> Richard G4DYA
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft@mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to rmcgraw@blomand.net
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to elecraft@progressive-comp.com
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic