[prev in list] [next in list] [prev in thread] [next in thread]
List: elecraft
Subject: [Elecraft] K2 PA100. I hate it when I am stupid.
From: "Rich McCabe" <r.mccabe () 1967z28 ! com>
Date: 2004-08-30 3:07:45
Message-ID: 000b01c48e3e$8e4946e0$9500a8c0 () inspiron
[Download RAW message or body]
Well finished the 100 watt PA tonight and did not spend as much time
checking components as I should have :(
All resistance checks where good and everything checked out (fan, swr cal,
ect) until I got to the point where I powered the K2 radio from the high
current supply. I detected a "crackle" on power and shut it down to check.
All looked OK so I tried it again. Seemed OK and everything looked good with
current draw but the bias would not adjust at all. Just stayed around 600.
So I started doing resistance checks and across the power plug it was
several hundred ohms and not > 10K it should have been. This checked OK
originally without power. So I start lifting components to narrow it down
and I get back to U7 and if I had looked in the first place, I would have
noticed I put it in backwards <sigh>
So upon removal the resistance across the power plug is back to normal. I am
sure U7 it toast since the resistance was OK before power and not after. Can
someone tell me if there is anything else I should order when I do? Maybe
Q5?
That is what you get when you dont follow directions !
73,
Rich
kdozv
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic