[prev in list] [next in list] [prev in thread] [next in thread]
List: dpdk-dev
Subject: [dpdk-dev] I couldn't manage to configure RSS
From: mahan () mahan ! org (Patrick Mahan)
Date: 2013-08-17 16:48:27
Message-ID: 2DD1C24F-E188-4CA0-B268-C87C9B55F7F1 () mahan ! org
[Download RAW message or body]
With test-pmd, you need to make sure you allow enough cores to handle each RSS queue. \
And as the previous poster mentioned, you must generate traffic to a wide range of \
destination addresses.
Patrick
Coming to you from deep inside Fortress Mahan
On Aug 17, 2013, at 8:57 AM, Hamed khanmirza <hamedkh at gmail.com> wrote:
> Hi,
>
> I successfully managed to run l2fw example and also l3fw with only one queue. But I \
> couldn't config the RSS in l3fw and also test-pmd application. I simply create two \
> queues per port on two lcores and set the RSS_ETH_IPV4 (I laso tried other \
> options). I generate a traffic with different destination addresses but all the \
> traffic goes to the first queue and the other queue in both applications is empty ! \
> I also fully read both application codes, api_reference, programmers guide, but \
> unfortunately couldn't find anyway to activate this feature. Have you any advice \
> for me? Is there any trick or other configuration I should enable? My Ethernet card \
> is X540, and I'm using Intel E5-2650 CPU on ubuntu LTS 12.0.4.
> Regards
> -Hamed
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic